Description

Product Introduction:
This is a two-component product consisting of one powder package and two supplementary liquids, reinforced with polymeric materials and fibers. It is a reliable and permanent moisture insulation that can resist positive and negative water pressure on concrete surfaces and cement structures. With excellent adhesion to the substrate, this product prevents cracking, provides optimal resistance, and reduces solar energy absorption. It is suitable for waterproofing all concrete surfaces such as tunnels, elevator pits, swimming pools, Jacuzzis, saunas, bathrooms, rooftops, and drinking water tanks, serving as a dependable alternative to traditional bitumen or isogam.

Instructions for Use
First, mix approximately 4 liters of WAC200 liquid with 4 kg of its special powder to create a slurry. Apply this mixture thoroughly to the surface using a brush or roller.
After it dries, lay a fiberglass mesh over the surface. Mix the remaining 12 kg of powder with 4 liters of WAC200 liquid to form a paste. Apply a 2 mm thick layer of this paste onto the surface using a spatula or trowel. Once dry, if any hairline cracks are observed, prepare the slurry again (as in the first step) and apply it to the surface with a brush or roller. After completion, you can proceed with installing tiles or ceramics.
It is worth noting that in places like elevator pits where water may still leak from certain points, first seal the water entry points using a quick-setting agent (plugger). Once dry, begin the waterproofing pack application.

Pre-Installation Measures
First, clean the target surface from any contamination, dust, and grease.
Open hairline and deep cracks using mechanical tools.
The best installation temperature is between 10 to 30 degrees Celsius.