D300
formulated special material cleaner​

Read more

D300 formulated special material cleaner​

A 410 High-Performance Slab Adhesive (Powder-Based) Single-Component System

Product Characteristics

​A 410 is a specialized single-component adhesive formulated from high-grade mineral powders, organic additives, and advanced polymers. Specifically reinforced with synthetic fibers, this product is designed for high-durability bonding on both floors and walls, suitable for interior and exterior environments. Its versatile formulation allows for reliable application on gypsum-based substrates and surfaces equipped with underfloor heating systems. It is an ideal choice for high-traffic areas, bathrooms, balconies, patios, and swimming pools.


 Combine one 20 kg bag of A410 with approximately 4.5 to 5 liters of clean water. It is mandatory to use a mechanical mixer to ensure a smooth, lump-free paste. If the mixture remains too stiff, gradually add a small amount of additional water and remix until the desired consistency is achieved.
Allow the adhesive to rest for 5 to 10 minutes to activate its chemical properties, then remix for one final minute. Using a notched trowel, apply the adhesive using the “double-spread” technique (to both the substrate and the back of the slab), ensuring all ridges are pulled in the same direction. Once the slab is in place, use a vibration tool to expel any air trapped underneath. Grouting should be deferred for at least 72 hours. During this curing phase, protect the installation from any pressure or vibrations that could lead to slab displacement

​The installation area must be completely sanitized from dust, debris, and oily residues. For “tile-on-tile” or “tile-on-stone” applications, mechanically abrade (scratch) at least two-thirds of the existing surface. For gypsum-based surfaces, the area must be scratched and treated with a high-quality primer before applying the adhesive.

Specification

Value

Physical State

Homogeneous powder

Color Variety – Specific Gravity

White – 1.4  g/cm3

Chloride

…..

Mixing Ratio with Water or Supplement

Approximately 23% to 26% of powder weight

Installation Temperature

+10 to +40 °C

Temperature Resistance (Fully Cured)

-25 to +80 °C

Tensile Strength

1.2  N/mm2

Shear Strength

1.2  N/mm2

Adhesive Tensile Strength (After water immersion)

1.2  N/mm2

Adhesive Tensile Strength (After heat exposure)

1.2  N/mm2

Chemical Resistance

……

Pot Life / Open Time

30 Minutes

Initial Drying Time

48 to 72 Hours after installation

Grouting Time

72 Hours after installation

Mortar Thickness – Consumption Rate

4 to 6 mm – 6 to 8kg/m2

Shelf Life and Storage Conditions

Maximum one year after production; keep away from moisture

 and direct sunlight.

 

N600
Surface Hydrophobic Resin-N600​

Read more

N600 Surface Hydrophobic Resin-N600​

Product Introduction:

N600 Surface Hydrophobic Resin is formulated based on transparent nano-resins. After application, it causes no change in the color of the treated surfaces. This product contains hydrophobic resins and does not require any additional additives; adding any other substance will destroy its unique properties.

  • The transparent coating is applied to the surface using a brush, roller, or spray.
  • The target surface must be completely dry. After applying the hydrophobic agent, the surface must not come into contact with moisture, water, or rain for 24 hours.
  • The hydrophobic surface will be fully ready after 24 hours.
  •  
  • Cleaning:First, the target surface must be thoroughly cleaned of any dust, dirt, or grease.
  • Repairing:Cracks and joints must be filled with appropriate materials (such as adhesive or repair mortar) and allowed to dry completely to ensure a smooth and uniform surface for applying the coating.